Step 1
Mount the GTR on the wall using double sided tape or screws next to the existing wall button of the garage door opener.
 |
|
Step 2
Put the wall button ribbon wire into the slot of the Easy Clip.
Ensure the ribbon wires are not twisted and lay flat inside the clip. It is not necessary to cut/open the plastic tubes of the ribbon wire.
 |
|
Step 3
Close the cover and press down to lock the cover using pliers, if necessary, to close the cover until you hear a "click".
  |
|
Step 4
View of the Easy Clip after the cover is closed.
 |
|
Step 5
View of the finished connection between the Wall Button, Easy Clip and GTR.
The LED of the GTR will flash (within 60 seconds) after connection.
Then you can use the G6 transmitter to control the GTR to open and close the Garage Door.
 |
|
Step 6
If the wires come from the wall, connect the two wires with PVC tube into the slot of the easy clip.
 |
|
Step 7
Ensure the two wires are not twisted and lay flat inside the clip, then press the cover to close the body.
 |
|
Step 8
Put the two wires into the slot of the easy clip.
The LED of the GTR will flash (within 60 seconds) after connection.
Then you can use the G6 transmitter to control the GTR to open and close the Garage Door.
 |
|
Step 9
If the wires are too thick to fit into the slot of the Easy Clip, just cut (remove) the easy clip and connect the two wires to the wall button directly.
 |
